Andrew 7.6-Meter ESA Bedienungsanleitung PDF herunterladen (Seite 14)

Step 3

Step 4

Raise 201313A beam assembly to upright position and attach 201315 supports to

201327A joint assembly as shown in Figure 7.

• Use 7/8 x 2-1/4 in. (57 mm) bolts and nuts.

•

Insert bolts from 201327A joint assembly to supports.

• Supports should be installed back-to-back with the flat of angle facing upwards.

• Tighten supports until assembly can support itself.

Installation Procedures

Figure 7

Attach 201301/201302 rear pad assembly to 201315 supports as shown in Figure 8.

• Use 7/8 x 2-1/4 in. (57 mm) bolts and nuts

• Insert bolt from inside of rear pad assembly to outside of support

• Supports should be installed back-to-back with the edges forward and the flats of

angles facing rear

Figure 8

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 68 69

Keine Kommentare

Andrew 7.6-Meter ESA Bedienungsanleitung Seite 14