Andrew 7.6-Meter ESA Bedienungsanleitung PDF herunterladen (Seite 15)

Step 5

Step 6

Attach 201314 supports to 201301/201302 rear pad assemblies and 200884 joint

assembly as shown in Figure 9.

• Use 7/8 x 2-1/4 in. (57 mm) bolts and nuts

•

Insert bolt from inside of joint assembly to outside of support

• Supports should be installed back-to-back with the edges forward and the flats of

angles facing rear

Installation Procedures

Figure 9

Attach 201317 supports between angle pairs as shown in Figure 10. Select correspond-

ing mounting holes so that 201317 supports are parallel to 201313A beam assembly.

• Use 7/8 x 2-1/4 in. (57 mm) hardware

• Supports attached with edges inward and flats facing up.

Figure 10

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 68 69

Keine Kommentare

Andrew 7.6-Meter ESA Bedienungsanleitung Seite 15